AIR POWERED C/V BOOT INSTALLATION KIT

Air Powered Boot Installation Tool for CV Joints 
Professional tool for commercial or occasional use. 
Used for stretching of flexible rubber CV boots on automatic drive shaft assemblies 
When a CV boot or gaiter is split instead of dismantling the front axle and drive shaft assembly simply use this tool for accurate and time saving labour. 
The diameter of CV joints should be in the range of 20mm 110mm. 
Installs flexible steering and CV boots without removing axle from the vehicle or the CV joint from the axle 
Composite body with simple control valve. 
Suitable for cars / small vans and light commercial vehicles. 
Works from a 1/4in. BSP inlet attached to the rear end of the tool.